Nikon Z6ii USB not active

We tested as good as we can. But there will always be things we didn't find. If you found things that apparently don't work as they should, you can report them here so we can take care of them as soon as possible.
Post Reply
PhotoGregg
Posts: 2
Joined: July 21st, 2021, 11:29 pm

July 21st, 2021, 11:51 pm

Currently I cannot get the USB to show as active. Therefore I cannot review photos within the app or use any other functionality that rely on USB (Metering,etc..) I've seen several post about the potentially bad USB cables, so this week I ordered two new cables that arrived today. My symptoms did not change. It does appear that the other functions within the app are working OK. I'll be testing Timelapse and Autoramp later this week.
Here's the details with my equipment:
Z6ii camera firmware 1.2
Unleashed N2 Serial number 4721
Firmware A 1.4.5
Firmware B 1.4.9
Firmware C 1.4.0

Any advise on what I'm doing wrong would be greatly appreciated.
Thanks
Gregg
PhotoGregg
Posts: 2
Joined: July 21st, 2021, 11:29 pm

July 31st, 2021, 7:43 pm

After testing the Autoramp TL, most of the functions seem to work. There are now a couple of things that are of concern. When using the Autoramp TimeLapse if you move away from the app or even if my screen shuts off due to the Screen Timeout settings, all the configurations are reset to default once I move back into the app. The App and device still functioned as was originally set with the TimeLapse. You just could not tell that from the display on my phone.

Also, now in the Autoramp settings I only have one Algorithm available to me. It's the EV-meter Smoothing 24h. All other options are not available.

Any reply and/or response would be greatly appreciated.
Post Reply