Here are all the settings barcodes for the Unleashed Barcode Edition. These settings are for both the 2013 version of the Unleashed D200+/Dx000 Barcode Edition, as well as the new D300s version.

 +-DSCO-+

The scanner needs to be turned on and made discoverable using the barcode above – which is the first barcode on card #1. Then turn on the camera and plug in the Unleashed Barcode Edition, if it is not plugged in already. The Unleashed Barcode Edition will now connect to the scanner, which should beep to indicate it is now connected. Only now can you scan the below settings barcodes to change any of the settings of the Unleashed.

  • Encoding (D200+/Dx000 only – D300s is always Ascii)
    • Numeric
      512,S
    • Alphanumeric (Ascii)
      513,S
  • Mode
    • SingleID
      768,S
    • MultiID
      770,S
    • Packages 01-99
      778,S
    • Packages 01-99
      779,S
  • MultiID Timeout
    • 10s
      1034,S
    • 20s
      1044,S
    • 30s
      1054,S
    • 45s
      1069,S
    • 60s
      1084,S
    • 120s
      1144,S
    • 180s
      1204,S
  • Mode
    • SingleID
      768,S
    • MultiID
      770,S
    • Packages 01-99
      778,S
    • Packages A-Z
      779,S

Other special Barcodes

  • Delete
    0,D
  • Delete & Disconnect
    0,Q
  • Remote release 200ms
    200,R
  • Remote release 500ms
    500,R
  • Remote release 1s
    1000,R
  • Remote release 2s
    2000,R
Leave a Reply

Your email address will not be published. Required fields are marked *