The initial pairing is described in the instruction manual of each product. The instructions can be downloaded below. The pairing only needs to be done once at the beginning. From then on the Unleashed’09 remains paired with the GPS receiver even if you change the batteries of the camera or GPS receiver. Unleashed’09 D200+ english […] Read more…
Using the D5000 and D3100 we have actually just taken it off entirely – if you pull on it slowly but firmly, it will come out – if you do so at an angle, it comes out undamaged, so you can always replace it if you want to. Some customers have chosen to cut a […] Read more…
The Unleashed’09 is designed to always stay on the camera. This is why we integrated smart power saving functions. While active and taking pictures the Unleashed D200+ draws 11.0 mA from the camera. After 15 minutes of inactivity the Bluetooth® connection is disabled. It then only consumes 1.85 mA. After 45 minutes of inactivity the […] Read more…
If you have an Unleashed’09 D200+, a MC-DC2 is not necessary to do the pairing. In case you have an Unleashed’09 Dx000 a MC-DC2 remote control is necessary. Read more…
Please check check the FAQ “Pairing doesn’t work. what can I do?” Read more…
No. As long as you don’t set your Bluetooth GPS receiver back on factory settings the Unleashed and the receiver won’t get unpaired. Read more…
It might be that the Unleashed’09 casing is not transparent enough to see the LEDs properly. If you go somewhere darker you should be able to see the LED blinking red and green. If you still don’t see any LEDs blinking please make sure your Unleashed is plugged in properly so the Unleashed gets power […] Read more…
All our Unleashed’09 are tested before they get sent to you. Even though there might be a small chance the Unleashed is broken, please check the following point and retry the pairing routine: Your Unleashed’09 is plugged in the right way – be careful to not have it plugged in upside down. For the Unleashed’09 D200+: […] Read more…